Skip to content
Applewood Acres Garage Door SpecialistsRequest a visit
Open 24/7(289) 805-2215Call now
Person fitting a black strip along the bottom edge of a partly raised garage door, with a cracked strip lying on the floor. — Garage Door Bottom Seal Replacement, Fairview

Plan ahead Repairs · Fairview

Garage Door Bottom Seal Replacement in Fairview

With the door closed and the lights off, a bright line of daylight runs along the floor from one side to the other. Leaves and grit have blown in under it and gathered in a neat drift against the back wall.

Call now · open 24/7(289) 805-2215

Request a visit

In plain words

A seal visit runs in a set order. With the door closed, the technician looks for daylight along the floor line and notes whether the gap is even or concentrated at one point. The door is checked for level and the bottom section for straightness, then the retainer is identified and measured. The opener is disconnected and the door secured before the old strip comes out and the channels are cleaned. A new seal, cut a little long, is fed into the channels and trimmed. Finally the door is closed onto the new seal, the opener's limits are reset, and the reversing test is run before the tools go away.

Sound familiar?

The gap under the door is a finger wide at one end and nothing at the other. The door itself looks straight, but the floor drops away toward the corner where the slab has settled, and drafts pour through the wedge.

How the visit goes

Garage Door Bottom Seal Replacement · Fairview

How the visit goes

Technician in a mesh cap lifting the white cover of a ceiling opener while a red screwdriver points at the wiring inside. — Fairview
  1. 1

    The floor and the threshold

    The concrete under the door is half of the seal. The technician looks at the slope of the driveway toward the opening, the condition of the slab edge where the seal lands, cracks, spalled patches and any step between the slab and the apron. A garage floor that has heaved or settled over the decades is common, and the shape it has taken decides whether a standard seal, a taller bulb profile or a threshold seal glued to the floor gives the most even contact. Where water arrives from outside, the path it takes is noted so the seal and any threshold are placed to meet it.

  2. 2

    Fitting a new retainer where needed

    If the inspection found a retainer that is bent, corroded or spread open, it is replaced before the seal goes in. The old extrusion is unscrewed or its rivets drilled out, the bottom rail is cleaned and any rust treated, and a new aluminum retainer is fixed straight along the rail with fresh self-drilling screws, checked with a straightedge so the channels run true. Fastener heads are sealed against meltwater. On a door whose channel was moulded into a plastic bottom cap, a screw-on retainer is fitted over the rail so a standard seal can be used from now on.

  3. 3

    What to look for each season

    Once a season, close the door, turn off the lights and look along the floor. You are checking for a line of daylight, a corner where the seal hovers, an end that has slipped from its channel, and cracks along the fold of the bulb. Run a hand along the strip for stiff or brittle patches. Then watch the door close under power once and notice how it lands. A change in any of these is worth a call while the fix is a seal or an adjustment rather than a torn strip dragged through a winter. The check takes less time than reading this paragraph.

In the van

  • Silicone spray lubricant
  • Track clamps
  • Self-drilling retainer screws
  • Threshold seal and adhesive
  • T-style bottom seal

What affects the quote

  1. 1

    Door width

    A single door takes a shorter length of seal than a double, and the widest doors need more time to feed the strip evenly across. The quote starts from the width measured on the day.

  2. 2

    Seal profile and size

    T-style, bead and bulb profiles in different widths and heights sit at different points on the parts list, and the retainer on your door decides which one is used.

  3. 3

    Number of doors

    Two single doors are two seals, two inspections and two opener resets. The travel is shared, so doing both in one visit costs less than two separate calls.

Same fees day, night or weekend.

Have it ready

Before you call · 0 / 3

(289) 805-2215

Garage Door Bottom Seal Replacement: questions

Advice · (289) 805-2215

Can mice get past a garage door bottom seal?

A worn, hardened or chewed seal is one of their favourite routes, and even a small gap at a corner is enough. A fresh, continuous seal sized to the floor removes that route. For a garage with repeated trouble, seals with a stainless mesh embedded in the vinyl are available and resist chewing. Keeping the jamb seals sound at floor level matters just as much, since a gap beside the door serves them equally well.

What does a new bottom seal do about water coming in?

It closes the gap between the door and the slab so rain and meltwater meet a continuous barrier. Where the driveway slopes toward the garage, or the slab edge has dipped, the seal alone is working against gravity, and a threshold seal glued to the floor adds a lip that turns water back toward the drive. The technician looks at where the water comes from and recommends the combination that suits your threshold.

Can the seal be replaced in the middle of winter?

Yes, and winter is when most people notice they need one. Vinyl is stiffer in the cold, so the technician keeps the new roll warm until it is fed and takes a little longer working it across the channels. A seal frozen to the floor is freed by hand first. The door is then closed onto the new strip and the opener reset exactly as in summer, and the garage is sealed for the rest of the season.

Peel, Ontario

Fairview information

Town
Fairview, Peel, Ontario
In business
32 years
Hours
Open 24/7 · nights, weekends and holidays, same fees
Visits
On-site assessment preferred. Request a visit or call.

What the census means at the door

38%

Homes of every age. About 38% of homes in Mississauga were built in 1980 or earlier, according to the 2021 Census.

Where housing ages are mixed, many older houses have already had a newer door and opener fitted, so the door's age and the house's age are not the same thing. The technician reads the door itself, its spring type, tracks and opener, before recommending anything.

37%

Single-detached houses make up about 37% of homes in Mississauga (2021 Census).

Townhouses built in rows tend to have identical doors from the same builder, so when springs and openers age they do so together along the street. Owners often arrange service for several doors at once, and we can plan a single visit that covers the row.

Source: Statistics Canada, 2021 Census of Population

Open Fairview in Google Maps

Open 24/7

Request a visit

With the door closed and the lights off, a bright line of daylight runs along the floor from one side to the other.

Call now · open 24/7(289) 805-2215
  • On-site assessment preferred
  • Same fees day, night or weekend
  • 32 years in business